When launching Mastercam from a workstation that needs to access the NetHASP for licensing, if it does not have access, one or both of the below pop-ups will occur.
Note: At any point that (version) is present enter/insert/reference the version of Matercam in question.
ie. A path states as ‘C:\Program Files\mcam(version)\common’
If you are working in Mastercam X9, the path will be ‘C:\Program Files\mcamX9/common’
Make sure the NhaspX is set correctly (Start > All Programs > Mastercam(version) > Utilities)
(The computer the NetHASP is located at)
Reboot your server and workstations. This will establish the connection to the server and restart the license manager.
It is possible the connection to the NetHASP was lost or the port is no longer working as expected. Move the NetHASP to another port.
Restart the license manager. This can be done through the services manager, through cmd, or you can reboot the server.
You need to be physically on the computer with the NetHASP.
To update through cmd…
Type: net stop “HASP Loader”
Type: net start “HASP Loader”
***If service is invalid, then it is not installed.
Reinstall the Licence Manager from http://www.mastercam.com/en-us/Support-Downloads-Drivers-and-Applets
Set the nethasp.ini on the workstations to look to the server’s IP address.
Open nethasp.ini in notepad
Note: You may need to save to the desktop then drag the file back in if you do not have rights to save here.
Do you have a topic or question you would like to see us cover? Let us know in the comment section below!